How To Use Fuel Busters Fuel Conditioners
1. Suggested Procedure For Use of Fuel Busters Gas Pills
It is important to state for the record that you cannot overdose your engine with too much conditioner (gasoline or diesel pills).
What follows is the Fuel Busters recommended usage procedure that should be followed when you purchase and first use the Fuel Busters gasoline or diesel pills (or diesel wafers) for your vehicle. We recommend that the first treatment requires that a triple dose of pills or wafers be used for the first tank full of fuel. The second and also the third treatments also require that a triple dose of pills be used. After you have repeated this procedure for three gas or diesel fuel fill ups then all subsequent fill ups will require a single dose per refill.
The Fuel Busters gasoline pills effectively condition 80 liters (20 gallons) per pill. The Fuel Busters gasoline pill, because of the caustic nature of gasoline, will dissolve while "static," that is, with no agitation, in about two hours in a jar of gasoline. However, when inserted in a vehicle's fuel tank before fill up, it will dissolve within minutes.
To use the Fuel Busters gasoline pill remove the individual pill from the foil backing. Etch out the form of the pill on the back of the blister pack with a small knife or paper clip and remove the pill from the package. Insert the pill into the nozzle of the gasoline pump, push the nozzle of the gasoline hose past the gas protector flap, activate the pump and fill your fuel tank. Most vehicles have a small wire mesh filter about seven inches beyond the refueling spout that will prevent the tablet from entering the fuel tank. The agitation of the gasoline fuel passing over the pill during your refueling will break the pill down and fully dissolve it for maximum distribution throughout the gasoline fuel.
2. Suggested Procedure For Use of Fuel Busters Diesel Pills
The Fuel Busters diesel pill comes in two different sizes. A small pill that treats 80 liters (20 gallons) and a large wafer that treats 800 liters (200 gallons). The diesel pill will take about 48 hours to dissolve while "static" in a jar of diesel, but will break down in about ten minutes if broken up and placed in an agitated tank prior to refueling. We recommend that a triple dose of pills or wafers be used for the very first tank full of fuel. The second and third treatments also require that a triple dose of pills be used. After you have repeated this procedure for three diesel fuel fill ups all subsequent fill ups will require a single dose per refill.
To install, the foil backing should be etched out on the back of the blister pack surrounding the pill with a small knife or paper clip and then the pill or wafer should be cut up and dumped into the tank prior to fill up, so it will dissolve faster.
3. Storage
All pills should be stored in a room temperature of about 72° F or less. The bio components of the pills begin to get soft when temperatures exceed 90° F and will melt when temperatures reach 110° F, as would occur in a vehicle on a hot summer day. However, because the pills are homogenized, they can be recovered by turning the blister pack, plastic side down, while the pill is still in a gel form and returning the package to room temperature. The pill will resettle into the plastic cradle of the blister pack and reform. The pill is still totally useable either way as the ester ingredients are still active; however insertion may be more difficult if the pill has semi dissolved and reformed improperly in which case it must be scraped out and into your fuel tank.
top of page
|